sunfounder

Arduino Raspberry Pi Holder Breadboard Kit

Introduction
This RAB Holder Kit provides you all the necessary components for a simple experiment, including threads for easy screwing, slots for plugging wires, an RAB holder, nine LEDs, and ten 1K current-limiting resistors, thus you can start the experiment right away.
With this kit, you can fix your Arduino board, Raspberry Pi, and breadboard on the RAB Holder, free of careless short circuits on a metal desk or caused by some metal parts underneath.
What’s more, it also comes with 65pcs jumper wires with different length in various colors, therefore, you can just plug them into the control board and breadboard to build circuits, no bothering about complicated soldering.

SPECIFICATIONS
200 x 135 mm (7.87 x 5.31 inch)

PACKAGE INCLUDES
1 x RAB Holder
1 x 830-Point Breadboard
65 x Jumper Wire
1 x 20cm FC40 40pin Flat Rainbow Ribbon Cable
10 x 1kΩ Resistor
1 x Screwdriver
1 x T-Extension
9 x LED (3 red, 3 yellow, and 3 green)
12 x Screws(4 x M3*6 screws ,4 x PWM2*6 screw, 4 x PWM2*4 screws)